8/18/2023 0 Comments Oncourse systems hayyenslab![]() If you are experiencing symptoms of hyperglycemia, contact your healthcare professional immediately. The test strip port on the meter may be dirty.Parts of the test strip may have become covered in grease, oil, or lotion.The test strip may have been mishandled by vigorous bending or shaking.The test strip may have been improperly stored (e.g., hot, humid conditions) or may be expired.This has to be clear for pulling the blood up. The strip was close to or pushed against the skin on the finger, which can block the siphon door on the end of the strip.The strip was pulled away from the blood sample before the test window was filled.The higher the number setting, the deeper the puncture. ![]() ![]() The lancing device needs to be set to a higher setting for a deeper puncture which will produce more blood.The lancet (needle) is dull and not puncturing deep enough.The blood was "dropped" on the strip rather than touching the end of the strip to the edge of the blood drop to siphon it up in the strip.The correct steps are to first, insert the test strip into the meter, wait for the fill screen to appear, and then bring the bottom of the strip to the drop on the finger. The blood sample was put on the test strip before inserting the test strip.If this message appears after the 1-2-3 countdown instead of a result, it may indicate you applied more blood after testing began.If the message appears during a test, the test strip may have been removed too early.If this message appears at the moment the test strip is inserted, the test strip may be wet or damaged.This could happen for the following reasons: IMPORTANT: If you are experiencing symptoms of hypo- or hyperglycemia or you receive multiple error messages, please dial 9-1-1 or emergency services.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |